The Robin HR100 is a French four seat light monoplane. It is a low wing cantilever monoplane with a conventional cantilever tail unit and a fixed tricycle landing gear. It was often used as a trainer aircraft because of its predictable and stable flight characteristics.

The AeroSky Robin HR100 is constructed from durable and lightweight EPO foam. Large horizontal and vertical stabilizers coupled with large wings mounted low on the fuselage give this plane a smooth character. The main wings are reinforced with balsa to give it a rigid and flex free profile. Fixed tricycle landing gears are easily installed and the front wheel is steerable allowing the pilot to taxi the plane easily around the runway. The Robin HR100 is setup for electric and takes a 4011 Brushless Outrunner Motor. A 30amp ESC and 11.1v 2200mah Li-Po battery is also recommended as a power setup. Three 9 gram servos for the control surfaces and a larger 40 gram servo is recommended for the steerable nose wheel. Cutouts are made for the servos and motor mounts allowing this plane to be built in a short amount of time.

Specifications:
Length: 1050mm
Wing Span: 1250mm
Flying Weight: 1000grams
Propeller: 10x6

Center of Gravity 75mm

Required to Fly:
Assembly of Plane
4 Channel Transmitter
4 Channel Receiver
(Recommended Electronics)
4011 Brushless Outrunner Motor
11.1v 20C Li-Po Battery
Li-Po Battery Charger
30A Brushless Electronic Speed Controller
Three 9gram Servos
One 40gram Servo (Front Wheel Steering)