The new Pioneer glider from AirWingRC is efficiently built with a strong and durable airframe. AirWingRC has created this wonderfully and exciting electric glider in impact absorbing and resilient EPO foam. Compared to other flying gliders the Pioneer is no ordinary glider. The Pioneer does not have a tail section which makes it fly very similar to a flying wing airplane however still using the same controls as a plane with a tail without having to use any mixings. The inboard control functions the elevators and the outboard controls functions the aileron control.


Despite of its large size, the Pioneer has been designed to handle well when flown fast or slow. It has an excellent glide ratio characteristic which will make it a fun plane for all around flying.

Features

Easy to assemble with detailed instructions
Lightweight, strong, and crash resistant EPO Foam
Powerful 3536-KV1000 Brushless motor
Single landing wheel design for landing on all types or surfaces
Folding prop to reduce drag
Wings features support sparing for less flex in high speed flights
Highly affordable Almost Ready to fly version

Specs

Material: EPO
Wingspan: 2450mm (96.5in)
Length: 800mm (31.5in)
Motor: 3536-KV1000 Brushless Outrunner Motor
ESC:40A
Servo: 5x 9g servos
Propeller: 2-bladed Folding Prop

Needed to complete:

Battery: 11.1V, 3S 2600mAh 25C Li-polymer and Lipo Charger
Control system: 4 CH Transmitter and Receiver
Assembly of plane

Note:

For proper control functions the outboards are ailerons and the inboard are elevator controls. 3-4 degrees of "up" elevator is recommended for the first flight to ensure proper take off. Also never launch with full throttle because the glider will have a tendency to torque over.